Skip to main content Skip to navigation
Washington State University Health Sciences Spokane

Biomedical Engineering and Design


Note: As a reminder, it is best practice to plan for a 3 to 5 percent yearly rate increase when proposing studies and submitting grants.

Technical SupportWSUOutside WSU
Design Work$130/hour$130/hour
ConsumablesAt CostCost + 10%
STAT FeeAdd 50%
Add 50%
3D Printing 
Printer use time$3.00/hour
Setup, consumables & wear$5.00 (one-time charge)
Material charge: Dupont Zytel$3.50/cubic inch
Material charge: Formlabs liquid resin$5.00/cubic inch
Material charge: Nylon, NylonX, Tough PLA, PETG$2.50/cubic inch
Material charge: PLA or ABS$1.75/cubic inch

Payment Policy

  • Fifty percent (50%) is due at the initiation of the project.
  • Invoices will be issued every 60 days or whenever expenses exceed $500. An invoice for the balance will be issued upon completion of the project.
  • The buyer has two weeks to register a complaint about or report any damage to the delivered product. If the complaint or damage is caused by the Biomedical Engineering and Design Research Center, the reinstatement work will be done at no additional charge to the customer.